You Will Need:
- 1 yard of fabric. Get 1/2 yard of each coordinating fabric if you want 2 fabrics on your apron (like the one pictured)
- 2 yards of ribbon (I used 2 different colors of ribbon and bought 2 yards of each)
- Thread
- Sewing Machine
- Any embellishments you would like to use: Buttons, silk or felt flowers, etc
- Put your fabric wrong sides together, pin on the pattern and cut. Do this twice (for front and back panels)
- If you would like pockets, fold your fabric in half and cut your desired pocket shape out of both layers.
- Ribbon: cut four 6-inch strips, and two 24-inch strips
Sewing the Pocket:
- Put your pocket fabric wrong sides together and sew around all sides, leaving a small gap open.
- Turn right side out, push out corners, press with iron and close gap.
- Select apron panel piece that you would like to be the front, and pin pocket(s) into desired location.
- Sew pocket(s) to apron on three sides, leaving top open
- Take 2 of the four panel pieces and place them wrong sides together (one of each pattern, if using 2)
- On each shoulder, place one 6" strip of ribbon between the pieces of fabric so only a little bit of the ribbon shows out the top, and pin in place (it will seem that you are sewing the ribbon inside the panels, but when you turn them inside out, you will have sewn the ribbon into the shoulder, leaving the majority free to use for tying)
- Sew completely around entire panel, leaving a small gap open
- With scissors, snip seam around curves of neckline every inch or so to add some give to the neckline.
- Turn fabric right side out, push out corners, press and close gap.
- Repeat all steps for second panel.
Adding the Waist Ribbon:
- Using one piece of 24" ribbon, mark center of ribbon with a pin, then pin across panel at desired chest height.
- Attach ribbon to panel by stitching along length of ribbon
- Attach ribbon to second panel (make sure both panel ribbon placements match!)
- Knot shoulder ribbons, joining the panels, and you're done!
- Stitching an extra line of stitching at the edges of the pocket opening and where the waist ribbon leaves the fabric will prevent future tearing.
- Treating the ends of your ribbon with "fray check" or "fray no more" will prevent unraveling.
The Pattern:
Ok everyone, I tried for MONTHS to try and figure out a way to post the pattern so that it would print "actual size." I drew it out on three separate sheets of paper so you could print it and then tape it together and cut it out. Sorry, but it didn't work! I finally had to just photograph the pages to post them. I included measurements on the pattern, so hopefully you can still create your own without too much trouble. Also, the pattern is only one half of the apron. You can use the dimensions to draw out a whole pattern on a big piece of paper, or you can just do the half pattern, fold your fabric, and place the long dotted line of the pattern along the fold of your fabric to cut. If you get stuck or need help, just post a comment and I'll try to answer you ASAP :)
3 comments:
Oh My. I think I (heart) you. I stumbled in here because I am going to make an apron for my toddler daughter and I swear that you have directions for every little girl craft I have supplies ready for (hair clips, tutus, FELT COOKIES!) I have bookmarked you and I swear this is destiny. Thank you thank you thank you for sharing!!!!!! You are AWESOME!
Thanks so much for the Apron's pattern and idea. I'm going to make one for my one year old daugther. I played around with your scanned pattern pictures and finally got the actual size from the printout. Here is the measurement of the printout pictures:
Pattern#1 15cm X 20cm
Pattern#2 17.62cm X 23.5cm
Pattern#3 22.8cm X 17.1cm
Hi, I'm the one who posted comment on Feb 26,09. I just want to show you the apron I made using your pattern. Here is the picture:
http://farm4.static.flickr.com/3598/3321900728_a00585bdaa.jpg?v=0
Post a Comment